Your cart is empty.
Your cart is empty.Product Description
- EASY TO INSTALL: The cover of the meter head can be embedded on the top of the device, which is convenient and quick to install.
- DIGITAL DISPLAY DIGITS: 4 Digit. Four‑digit red digital tube display, and the brightness of the display can be set, which is very practical.
- EASY TO INSTALL: The interface adopts KF128‑5.08 high quality environmental protection copper terminal.
- HIGH PRECISION: The position of the decimal point can be set, the Baud rate can be set, and the display result is more accurate.
- MATERIAL: PLC display is made of high quality material of ABS, which makes it lightweight, not easy to damage and durable.
Burt Munger
Reviewed in the United States on April 16, 2024
This is working well for me. It is larger than I thought, at 96mm wide and 48mm tall (faceplate), and 29mm thick. The instructions are not obvious but here's the modbus 485 scoop:modbus address 0 is for the data bits. These are the values that will appear on the displaymodbus address 1 is for the decimal position. 00= XXXX, 01= XXX.X, 02= XX.XX, 03= X.XXXmodbus address 2 is for the brightness. 00 is the dimmest and 07 is the brightestmodbus address 3 is for the baud rate. 00 = 1200, 01 = 2400, 02 = 4800, 03 = 9600,. etc..These match the description above that use numbers 1..4, the address is one less. Serial default is 9600-8-N-1, and the modbus device ID is 1. I put 24VDC on VCC and GND, rs485 on A+ and B- as shown, didn't use COM. Altogether lots of bang for the buck for an informal project (I'd worry in a washdown panel environment, and it doesn't seem to have a way to blank leading zeros, but I just needed some bright numbers on a panel and this is perfect)
Recommended Products
$62.67
$ 27 .99 $27.99