Your cart is empty.
Your cart is empty.Customer
Reviewed in the United States on March 16, 2025
Seems to be working after I was able to put all the screws back in it that fell out I assume during shipping
Gary E. VanderPutten
Reviewed in the United States on January 24, 2025
We have attached individual K type thin wire sensors to key hot water pipes in our building; we use an OMEGA hand held meter. The sensors are seated firmly with insulated tape and are the most accurate (matches our FLUKE) we have found. . The new OMEGA touch sensor must remain in contact for about 30 seconds and is typically 5 degrees less than the permanent one, but accurate enough knowing that difference.
BF
Reviewed in the United States on January 1, 2025
Solid, well made, accurate, easy to use, very inexpensive.
Tech
Reviewed in the United States on April 13, 2024
Compared it to a Cooper temp clamp and this thing was almost 20 degrees off. Used it for about 30 seconds then found the nearest trash can. Unless you’re trying to read 1000 degrees and a little variance doesn’t matter this thing is not worth getting.
Emmy
Reviewed in the United States on August 28, 2021
pretty good for the value
Joseph Kost
Reviewed in the United States on July 11, 2020
Does the job definitely not for everyday use but very good for the price and pretty accurate
Karl A. Richardson
Reviewed in the United States on February 21, 2020
This does work well. I bough it to use with PEAKMETER K Type Thermometer I purchased at the same time. However, I was going to use it on plastic extrusion machinery running 700-800F and I have to keep it in contact with dies at those temps. It made me nervous how slow the meter was taking to settle at its reading and I didn’t want to keep the sensor in contact with such high heat for too long. I’ve used $200 units that read in a few seconds. After 15-20 seconds I stopped because I didn’t want to render it useless. It should work fine on engines, motors, etc. but it does work well.
Blake Garretson
Reviewed in the United States on November 13, 2019
The single thing going for this probe is its price. A probe from Fluke or Omega would be $100-$150 for something like this, and I paid $13. Is the quality the same? Not even close. The build quality and fit and finish are poor, and the metal clamp that protects the cable actually came off in the box. However, the screw went right back in and it was fine after that. Most importantly, the accuracy seems fine. When I compare the readings from a much more expensive probe, I'm generally within one degree. I bought this probe specifically because I have some applications that may damage the probe, and I didn't want to worry about wrecking an expensive probe. At the same time, I want something fairly accurate, and so far it seems to fit the bill nicely.
Recommended Products
